INDEX
INSTRUCTIONS Page
Lubrication schedule 7100 & 7150 2
Lubrication schedule 8100, 8150 & 8500 3
Lubrication schedule 8555 4
Lubrication schedule 9500 5
Lubrication schedule 1010 6
1.1 Specifications 7100 & 7150 7
1.2 Specifications 8100 & 8150 8
1.3 Specifications 8500 & 8555 9
1.4 Specifications 9500 & 1010 10
2.1 Explanation of pictograms 11
2.2 Safety decals maintenance 12
2.3 Location of safety decals 13
3 Safety 14
4 Identification 14
5 Use of the Tomahawk 14
6 Use on the public highway 15
7 Preparation of the machine 15
8 Preparation of the tractor 15
9 Fitting the machine onto the tractor 16
10 Operating instructions - loading 17
11 Operating instructions - discharge 19
12 Machine protective devices 21
13 Maintenance 21
13.1 Safety 21
13.2 Blades 21
13.3 Bed chain 22
13.4 Bale restraint beam adjustment and removal 22
13.5 Dual chop sieve removal 23
13.6 Crossbeater shear bolts 23
13.7 Gearbox 23
13.8 Drive chains 23
13.9 Swivel chute 23
13.10 Hydraulics 23
13.11 Electric controls for solenoid valve 24
13.12 Slip clutch 24
13.13 PTO shaft 24
13.14 Wheel changing 25
13.15 Wheel nuts 25
13.16 Tyre pressures 25
13.17 Hub caps 26
13.18 Wheel bearings 26
13.19 Lubrication of wheel bearings 26
13.20 Handbrake (1010 models) 27
13.21 Service brake maintenance 27
13.22 Service brake adjustment 28
13.23 Pneumatic brakes 29
13.24 Lubrication 29
13.25 Maintenance schedule 30
14 Special tools for repairs 30
15 Optional extras 30
16 Machine storage 31
17 Disposal 31
Fault finding chart - Part 1 32
Fault finding chart - Part 2 33
Fault finding chart - Part 3 34
To Next Page
Loading...
Need help?
General
