Preparation
19
Connecting a Bluetooth
®
device
1
Take both earphones (L and R) out of the charging cradle.
• When pairing with a device for the first time:
This unit will start to search for a Bluetooth
®
device to connect to, and the earphone LEDs will light alternately
in blue and red.
• When pairing with a device after the first time:
Both earphones should be placed temporarily in the charging cradle for 10 seconds.
After that remove them from the cradle and within 5 seconds while the earphone LED lights (blue), touch and
hold the sensor (L or R) for 7 seconds until the LED starts flashing Red/Blue, indicating that you have entered
the pairing mode.
2
Turn on the Bluetooth
®
device and enable the Bluetooth
®
function.
3
From the Bluetooth
®
menu of the Bluetooth
®
device,
select device name “EAH-AZ60” or “EAH-AZ40”.
• A BD address (Bluetooth
®
Device address: an alphanumeric character
string that is displayed by and unique to the device) may be displayed
before “EAH-AZ60” or “EAH-AZ40” is displayed.
• If prompted for a passkey, input the passkey “0000 (four zeros)” of this
unit.
• When the earphone LEDs blink (blue)* twice at approximately 5 second
intervals, pairing has been completed and connection has been
established.
* The batteries are low when they are blinking in red.
4
Confirm that the earphones and the Bluetooth
®
device are connected.
Note
• It is easier to pair if you disable the Bluetooth
®
function of the first device when pairing with a device after the first.
• When pairing with a device after the first time, if the connection with the device does not complete within 5 minutes,
the pairing mode on the earphones cancels and they transition to connection standby mode. Perform pairing again.
• You can pair a maximum of 10 Bluetooth
®
devices with the earphones. When you pair a device after the maximum
has been exceeded, previous devices are overwritten. To use overwritten devices again, do the pairing again.
Preparation
• Put the earphones into the charging cradle.
• Place the Bluetooth
®
device within approx. 1 m from the unit.
• Check the device operation using its operation instructions as required.
• Using the “Technics Audio Connect” app (free of charge) makes connecting with Bluetooth
®
simple.
Connecting by pairing (registering) your earphones with a Bluetooth
®
device
Bluetooth
Bluetooth ON
EAH-AZ60
Device
e.g. [EAH-AZ60]
Select
eah_az60_az40_pnqp1675za_full_eng_s.book 19 ページ ２０２１年９月２８日 火曜日 午前１０時７分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
