Technics Quartz ST-G45A User Manual

@ “Most-recent” memory
The most-recent memory is a system by which the unit
“remembers” the FM or AM broadcast station last heard when
this unit is turned off, and automatically tunes to that station the
next time the power is turned on.
@ “Back-up” memory
This is the function which preserves the preset memory and
most-recent memory functions. In the event of a power failure,
or if the power cord of the tuner is disconnected from the
electric outlet, the back-up memory will preserve the preset
memory and most-recent memory functions for as long as
approximately one week.
B To Prevent Erasing the Memory
If the power supply is interrupted for one week or longer, the
memory settings will be erased.
For example: .
1). If the power cord is disconnected from the electric outlet,
2) If an audio timer is used and the timer does not operate the
tuner for a week or longer,
3) If a power failure occurs, etc.
If any of the above occurs, the memory will have to be reset.
The memory in this unit is maintained by a capacitor. If the
power supply is interrupted for a week or longer, set the power
switch of the tuner to the “on” position for thirty minutes or more
in order to recharge the capacitor. Then reprogram the memory
(pages 6 and 7).
Manual memory presetting . .
Stations can be freely preset to any desired channel.
1 “on” (a— =) y,
Channel display
Memory indicator
Technics — Gusez syntnesiz hy AM/FM Stereo Tune} ST-G45.\
peers iar \
we BB WD ne’3
™ | ELS wccn
While the memory indicator is illuminated,
press the button of the desired channel.
When the button is pressed, the memory
indicator illumination will stop, and the presetting
is complete.
© To preset channels 1 through 8:
Press the button momentarily,
(
and then release. (Preset
channel number is displayed
Pity
on
the
channel
display.)
© To preset channels 9 through 16: af
Press
the
button
slightly
longer,
SS)
and then release. (Preset channel
number is displayed on the channel display.)
If the memory indication illumination stops before
you press the button, once again repeat step @© and
then step ©).
Enter the name (call sign, etc.) of the preset
broadcasting station on the station memory
file sheet (page 8).
This completes the procedures for presetting radio
broadcast frequencies. The other preset-tuning buttons
can be preset in the same way by following steps @
through ©.
CST-G45A )
“FM”: for FM broadcasts
“AM”:
for
AM
broadcasts
“FM”: for FM broadcasts
“MW”: for MW broadcasts
Before presetting the broadcasting
stations, press to select the
appropriate frequency step for
your locality.
(Refer to page 5.)
“LW”: for LW broadcasts
ST-G45A
Linear Smitching MPx
Press the appropriate tuning button to
tune to the desired broadcast.
Tuning
Press the left button to change the frequency
downward, and press the right button to change
the frequency upward.
e Automatic tuning
Press the button. When the frequency
indication begins to change, release
the button (a broadcasting station
will be selected automatically).
Repeat this operation until the
desired station is found.
® Manual tuning
Press the button momentarily and es
tune to the desired station. The (
frequency will change each time
ky
the button is pressed.
Press momentarily, and then release.
(The memory indicator will illuminate for approximately
4 seconds.)
Note:
If the button is pressed
continuously, the frequency will
begin to change, and the memory
will be preset automatically.
To stop the automatic memory
presetting, once again press either
the “up” button or the “down”
button.
pes
(
at
ENGLISH

Technics Quartz ST-G45A Specifications

General

Brand	Technics
Model	Quartz ST-G45A
Category	Tuner
Language	English