Technics SA-C600 User Manual

104
(Continued)
Remote control
The remote control does not work properly.
• The batteries are depleted or inserted incorrectly.
(⇒ 19)
• To avoid interference, please do not put any
objects in front of signal sensor. (⇒ 14)
• If the remote control mode of the remote control
differs from that of this unit, match the mode of
the remote control to the mode of this unit. (⇒ 19)
Messages
Adjust CLOCK
• Set the clock before setting the timer. (⇒ 86)
Adjust Play Timer
• Set the starting time and finishing time of the
timer. (⇒ 87)
Auto Off
• The unit has been left unused for about
20 minutes and will shut down within a minute.
Press any button to cancel it.
Checking Device
• The unit is checking the connected USB device.
After this display has disappeared, start operating.
Connect to Network
• Connect this unit to the network and then wait for
the start of the Firmware Update via Internet.
(⇒ 93)
Connect USB Device
• Download the latest firmware on the USB flash
memory and try again. (⇒ 94)
Download Fail
• The firmware download has failed. Press any
button to exit. Please try again later.
• The server cannot be found. Press any button to
exit. Make sure that the network is connected to
the internet.
Empty
• The selected folder is empty. Move tracks into the
folder and retry the operation.
• The server is not found on the network. Check to
see if the server is connected to the same network
as this unit, and retry the connection to this unit.
(⇒ 26)
• No Internet Radio station is registered to the
favorite list. Add a station to the list. (⇒ 62)
• No station or playlist is registered to [FAV]. Add an
item to the list. (⇒ 83)
Error
• Incorrect operation is performed. Read the
instructions and try again.

Technics SA-C600 Specifications

General

Brand	Technics
Model	SA-C600
Category	Car Receiver
Language	English