Technics SA-DA10 Service Manual

file:///C|/Documents%20and%20Settings/Administrateur/Mes%20documents/service/SA-DA10/p03.htm
1 Safety Precaution
TOP PREVIOUS NEXT
(This“Safety Precaution” is applied only in U.S.A.)
1. Before servicing, unplug the power cord to prevent an electric shock.
2. When replacing parts, use only manufacturer’s recommended components for safety.
3. Check the condition of the power cord. Replace if wear or damage is evident.
4. After servicing, be sure to restore the lead dress, insulation barriers, insulation papers, shields, etc.
5. Before returning the serviced equipment to the customer, be sure to make the following insulation
resistance test to prevent the customer from being exposed to a shock hazard.
Insulation Resistance Test
1. Unplug the power cord and short the two prongs of the plug with a jumper wire.
2. Turn on the power switch.
3. Measure the resistance value with ohmmeter between the jumper AC plug and each exposed
metal cabinet part, such as screw heads, antenna, control shafts, handle brackets, etc. Equipment
with antenna terminals should read between 3MΩ and 5.2MΩ toall exposed parts*. (Fig 1)
Equipment without antenna terminals should read approximately infinity to all exposed parts. (Fig
2)
*Note: Some exposed parts may be isolated from the chassis by design. These will read infinity.
4. If the measurement is outside the specified limits, there is a possibility of a shock hazard. The
equipment should be repaired and rechecked before it is returned to the customer.
file:///C|/Documents%20and%20Settings/Administrateur/Mes%20documents/service/SA-DA10/p03.htm (1 of 2) [21/01/2007 13:47:05]

Technics SA-DA10 Specifications