Technics SA-DA10 Service Manual

file:///C|/Documents%20and%20Settings/Administrateur/Mes%20documents/service/SA-DA10/p05.htm
3 Protection Circuitry
TOP PREVIOUS NEXT
The protection circuitry may have operated if either of the following conditions are noticed:
No sound is heard when the power is turned on.
Stops during a performance.
The function of this circuitry is to prevent circuitry damage if, for example, the positive and negative
speaker connection wires are“shorted”, or if speaker systems with an impedance less than the indicated
rated impedance ofthe amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first turned off and
then on again.
•@
TOP PREVIOUS NEXT
file:///C|/Documents%20and%20Settings/Administrateur/Mes%20documents/service/SA-DA10/p05.htm [21/01/2007 13:47:06]

Technics SA-DA10 Specifications