] 2 3 5
VCR 2 INPUT
J
O
POWER
[] I I
i , i, i , i, ; , i" i , i.;,io i.-J:_
I o I. ,l l oI,-J-I
VOLUMe
TAPEIDCC
VOLUME VCR 2 front
input terminals
Before operation, set VOLUME to the "0" position.
_ the speaker system(s) to be
_.J used.
_" "_ A and B refer to the speaker terminals
at the rear of the unit.
I....o_ _-/
I
Illuminates
If the button is pressed once more, the
indicator will switch off and no sound
will be heard from the speakers.
__Press 'tO"seiect 'the des'ired
source.
_kk_ VCR 1: To watch video tapes (VCR 1)
/ VCR 2: To watch video tapes (VCR 2)
If you use the VCR connected to
the VCR 2 front input terminals,
press VCR 2 INPUT to the
"FRONT" position.
TAPE/DCC: To listen to tape or
digital compact
cassette (DCC)
The tape monitor in-
dicator will appear.
(See below.)
CD: To listen to compact discs
TUNER: To listen to radio broad-
casts
PHONO: To listen to phono discs
a's]I!-'_',_1t___fllUll_'fA-l[lt__ Q.,(;lr411h] nlI
When using speakers with an impedance of 4 Q, press either
button A or button B for 4 seconds or more to set the im-
)edance on the main unit to LOW.
='EA'_"_ I--7 I"') I
Illuminates
(Press once again for 4 seconds or more to turn it off.)
Note that when this indicator is illuminated, speakers A and B
cannot both be used at the same time.
To change a speaker:
e.g. To use B speaker press A and the [] indicator goes out,
press B to activate the B speaker.
................St..t"ed*;i;,d,,O",Ce.....
(Refer to the appropriate operating in-
structions for details.)
@ volume level.
After listening Is finished
Be sure to reduce the volume level, and switch the power to the
standby condition by pressing POWER.
When tape monitor indicator illuminates or Is
flashing
This indicates that the tape monitor function of this unit is ON.
To listen to sources other than a tape or DCC, be sure to turn oft
the indicator by pressing TAPE/DCC _.
Illuminates or is flashing
/
_NJTO ITAPE M_ONIT_R J Ig_t[_
MANUAL
LOG<
® ., O C_. / ..
I
To Next Page
Loading...
Need help?
General
