Technics SC-CH404 User Manual

Connect the LW/MW loop antenna.
1. Attach the antenna holder to the rear panel of the tuner/sound
processor.
2. Clamp the antenna to the antenna holder and connect the an¬
tenna terminal to the rear panel of the tuner/sound processor.
3. Position the loop for the best reception.
Antenna holder
Press in until you hear a click.
You may attach the LW/MW antenna holder with screw (included) to
a rack or other structure. In this case, attach as showed in the figure
below. v
-Rack or other structure
To minimize noise pickup, keep the LW/MW loop antenna cord
along the heat outlet grille, and away from the flat cables.
-***+ ......
A Connect the right (R) and left (L) speaker
~ cables.
•Be sure to connect speaker cables before connecting the AC
power supply cord.
# 6h 8Q° ad irTlpedance 0f any s P® aker used w ‘th this unit must be
•Match the two wires from the left and right speaker cables with the
same coloured levers of the speaker terminals, then insert the
wires into the respective terminals.
1. S trip off the outer
covering, and twist
the center conductor.
=HS *4
15mm
Make sure the bare ends of the wires are pot unraveled. (If they are
twist them tight again.) (T) Q\ ’
2. (T) Tilt the iever back and
insert the wire. Jot 4 Jot |
(D Close the lever and pull ^
the cord gently to be ^
sure that it is secured. jJS
•The configuration of the
speaker terminals differs
depending on the area. q
3. Insert the wire to the ****~~^%^J
rear panel of the
amplifier, and close the lever. Y
•To prevent damage to circuitry,
never short-circuit positive (+)
and negative (-) speaker wires.
•Be sure to connect only positive (red) wires to positive (+) termi¬
nals and negative (black) wires to negative (-) terminals.
For United Kingdom
SURE TO READ THE CAUTION FOR AC
MAINS LEAD ON PAGE 4 BEFORE PROCEED¬
ING TO STEP 5.
Connect the AC power supply cord after you
have connected all other cables.
For United Kingdom
Insertion of Connector
Even when the connector Is per¬
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as
shown in the drawing.
However there is no problem
using the unit
.Connector
Approx. 6 mm'
-Appliance inlet
11

Technics SC-CH404 Specifications

General

Brand	Technics
Model	SC-CH404
Category	Stereo System
Language	English