Technics SC-CH404 User Manual

Making a recording from the radio broadcasts
CCRT recording function:
CCRT (Computer Control Record Tuning) is the function which iden¬
tifies the quality of the tape (concerning bias, level, equalizer) auto¬
matically and sets the most desirable recording condition. While the
CCRT setting is activated, the CCRT indicator flashes. After the
setting has completed, CCRT indicator stops flashing.
The CCRT setting will remain in the system's memory even after the
power is switched to the standby mode.
Notes
•Do not press I NT or EXT while the CCRT setting.
• Do not insert or remove the cassette tape after the CCRT setting
has completed. It cancels the CCRT setting.
•The CCRT setting may not be possible with the old cassette tape or
at around the end of the cassete tape. (The CCRT indicator starts
to flash in a high speed.) In this case, press □ and record without
using the CCRT function. (The CCRT indicator goes out.)
To take up the leader tape
The leader tape is the first few revolutions that you cannot record on.
To cancel the CCRT setting on the
way:
Press □ .
To record with the desired tone quality, follow the procedure below.
1. Select the desired tone quality. (See pages 38*40).
2. Follow the procedure of “Making a recording from the radio
broadcasts'' on page 29 .
ccrtO
To cancel the CCRT after the CCRT
setting has completed:
Press CCRT.
To erase a recorded sound (Deck 2):
When you make a new recording on a previously recorded tape, the
new recording will automatically erase what was previously re¬
corded. To erase a recorded sound without making a new recording,
perform the following steps:
t) Disconnect the microphone if it was connected.
2) Press INT to select the tape mode.
3) Insert the recorded tape into the cassette holder of deck 2.
4) Press DOLBY NR so that Dolby NR OUT indicator lights up.
5) Select the desired reverse mode.
6) Press R EC PAUSE.
7) Press the playback button (< or i>) corresponding to the side to
be erased.
i
When playing back such recordings, press ON/FLAT on the tuner/
sound processor to set to “FLAT’.
To record without any tonal effect
Press ON/FLAT on the tuner/sound processor to set to “FLAT'
(See page 38.)
About Dolby Noise Reduction system
Using Dolby NR reduces tape hiss in the high-frequency range. It
boosts the level of the high-frequency during recording, and lowers it
by the same amount during playback, simultaneously reducing high-
frequency interference incurred during the recording process.
Interference is reduced to about Vs. Use this type when playing a
tape in the Dolby NR mode.
Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol U3 are trademarks of
Dolby Laboratories Licensing Corporation.
Your attention is drawn to the fact that recording pre-recorded tapes
or discs on other published or broadcast material may infringe copy¬
right laws.
30

Technics SC-CH404 Specifications

General

Brand	Technics
Model	SC-CH404
Category	Stereo System
Language	English