Technics SC-CH404 User Manual

Sequential playback among 2 tapes
You can listen to two tapes consecutively with the procedure below.
Load cassettes in decks 1 and
2 .
Load with the side that you wish to listen
to first facing you in deck 1.
Press CLOSE to close each
deck’s cassette holder.
Press DOLBY NR if the cas¬
sette you want to play was re¬
corded with Dolby noise
reduction mode.
The DOLBY NR IN indicator will light up.
If the tape was not recorded using Dolby
NR mode, press DOLBY NR and the
DOLBY NR OUT indicator will light up.
Press REVERSE MODE to set
to the co mode.
Press DECK 1/2 to select deck
1 .
The DECK 1 indicator lights to show you
can select deck 1.
After repeating above operation 8 times,
the tape will automatically stop.
For your reference:
•You cannot select Dolby NR for deck 1 and deck 2 respectively.
•We recommend that you use cassette of the same type (Dolby
noise reduction) in both decks.
•You can also start playback from a position other than the forward
side of the tape in deck 1.
About priority of the deck:
When you load cassettes in both decks, DECK 1 or 2 indicator will
light to show which deck you loaded last.
When you switch on the power, DECK 1 indicator will light.

Technics SC-CH404 Specifications

General

Brand	Technics
Model	SC-CH404
Category	Stereo System
Language	English