Section IV – Diagrams
Figure 6. Wiring Diagram, PEX-P Transmitter Single Pulse
PEX-P Wire Codes:
Note: Pulse Inputs
• If EPLD (U24 chip) is Rev. 0, dual pulse will not function under 25 Hz. Only single pulse will count from 25 Hz
down to 3 Hz. Above 25 Hz, dual pulse will function as normal.
• If EPLD (U24 chip) is Rev. 1 or higher, dual pulse will function from 3 Hz and higher.
• Pulse doubling will not function for input pulses below 25 Hz.
PEX-P
RED
BLACK
WHITE
CN6
1
2
3 +12Vdc
4 Gnd
5
CN5
1 A+
2 A-
3
4
5 Shield
6
7
8
9
10
11
12
13
14
MNET Board
PEX-P, Dual Pulse
To Next Page
Loading...
Need help?
General
