USE AND MAINTENANCE MANUAL
REFRIGERATED CABINETS PERFEKT | PERFEKT PLUS
27
EN
5.2. FEET PLACEMENT AND ADJUSTMENT
The refrigerated cabinet must be positioned perfectly level in order to function properly and correctly drain the defrosting
condensate water, furthermore noisy motor vibrations are avoided.
To position the equipment, proceed as described below:
STEP ACTION IMAGE
1 Place the refrigerated cabinet in a perfectly vertical position.
2
Adjust the refrigerated cabinet screw feet (if required) to adjust its
level.
3 Check the flatness with a spirit level.
Check the correct positioning of the condensate water drain tray and the relevant drain.
Note: refrigerated cabinets with glass door(s) are supplied with a door handle with relevant fixing screws. Install and secure
the handle (at the customer’s expense), arrange the bottom grids inside it (on all cabinets).
5.3. CONDENSATE WATER DRAIN - DRAIN CONNECTION
The refrigerated cabinet is available in the following versions:
▪ with built-in monoblock unit equipped with automatic defrosting and evaporation of condensate water
▪ with set-up for a remote condensing unit supplied with siphon and drain pipe for connection.
Both of these cabinet versions are equipped with automatic defrosting and evaporation of condensate water, and are also
supplied with a drain pipe complete with siphon for connection to the water drainage mains.
Do not install the refrigerated cabinet without a siphon. Each drain must have its own
siphon.
It will be the user’s responsibility to connect to the water drainage mains.
condensate
drain
To Next Page
Loading...
Need help?
General
