USE AND MAINTENANCE MANUAL
REFRIGERATED CABINETS PERFEKT | PERFEKT PLUS
37
EN
9.2. TABLE OF CLEANING OPERATIONS
The following table lists a series of cleaning operations to be carried out according to the recommended frequency.
OPERATION
FREQUENCY
DAILY WEEKLY MONTHLY AT 6-MONTHLY
INTERVALS
YEARLY
Cleaning the evaporator.
■
External leaning of the cabinet.
■
Cleaning the inside of the door near the
gaskets.
■
Cleaning the bottom of the tank.
■
9.3. GENERAL CLEANING
Carry out general cleaning of the refrigerated cabinet using a soft cloth and non-aggressive products.
Remove the grids inside the refrigerated cabinet for better cleaning. Clean the grids with a soft cloth.
9.4. CLEANING THE CONDENSER
Disconnect the power supply before any cleaning operation.
The monoblock or the built-in condensing unit are placed externally in the upper part of the
refrigerated cabinet.
It is required to periodically clean the evaporator in order to ensure proper functioning of
the condensing unit. This cleaning depends mainly on the environment where the unit is
installed.
Use a jet of air blowing from the inside to the outside of the unit; if this is not possible, use
a long bristle brush on the outside of the evaporator.
Do not damage the refrigerant fluid circuit.
9.5. CLEANING THE GLASS (IF PRESENT)
Do not use abrasive material such as scotch bryte scourer, metal sponges or other materials
that may compromise the transparency of the glass and/or cause it to break.
To clean the glass (internal and external) use a suitable degreasing product, respecting its indications,
instructions for use and warnings. Rinse with a sponge soaked in water.
To Next Page
Loading...
Need help?
General
