Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock is set and
the water hardness parameter is set.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
Setting the clock
To set the clock, proceed as follows:
1. Press the Clock setting key. The hour
numbers will start to flash (not necessary if your
oven is first plugged in or after a power failure).
2. Turn the rotating knob to set the correct hour
value.
3. Press again the Clock setting key to set the
minutes. The minute numbers will start to flash.
4. Turn the rotating knob to set the correct minute
value.
5. To finish, press the Clock setting key again.
Hiding/Displaying the Clock
If the clock display disturbs you, you can hide it by
pressing the Clock setting key for 3 seconds. The
dots that separate the hours and minutes will flash
but the rest of the clock display will be hidden.
If you want to see the clock display again, press
the Clock setting key again for 3 seconds.
To Next Page
Loading...
Need help?
General
