12
SAFETY BLOCK
This function can be selected at any time
while using the oven.
To activate the function, press for a few
seconds until you hear a beep and the
symbol appears on the display. The oven is
locked.
If the oven is off and you activate the safety
block function, the oven will not work even if
a cooking function is selected.
If this function is activated while you are
cooking, it will only lock the display and
keys.
To deactivate the safety block function,
press for a few seconds until you hear a
beep.
SHOWROOM MODE
The showroom mode is used in showrooms,
to show the clients how the oven works as
activation of the heating loads.
To activate the showroom mode press
and .
To deactivate the function press and
again.
Teka Hydroclean
®
function
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to
accumulate. Clean the oven frequently.
PROGRAMING THE TEKA HYDROCLEAN
®
FUNCTION
Always run the cycle on a cold oven. The
result could be affected and the varnish
damaged if it is run when the oven is too hot.
First remove the trays and all accessories
from the oven interior, including the tray
supports and telescopic guide rails.
To do this, follow the instructions in the
installation and maintenance guide
accompanying the oven.
1. With the oven cold, spread a cloth out on
the bottom of the oven.
2. Gently pour 200 ml of water into the
bottom of the oven cavity.
3. Turn the control dial to position .
4. Set the temperature to 90º C.
5. Program a duration of 4 minutes on the
timer.
Do not pour water into a hot oven as this
can damage the enamel of the oven.
For best results, add a teaspoon of mild
washing up detergent to the glass of
water before pouring onto the cloth
To Next Page
Loading...
Need help?
General
Weight and Dimensions
