Connector Description
USB Host Four USB3 Host connectors (type A) to connect devices such as a mouse, keyboard, or other USB devices.
Tektronix does not provide support or device drivers for USB devices other than the optional mouse and
keyboard.
LAN RJ-45 connector to connect the instrument to a network.
Power Power cord input.
Marker outputs SMA type output connectors for marker signals. Four per channel.
These outputs are affected by the All Outputs Off state.
Sync In SMA type connector to use a synchronization signal from another AWG5200 series instrument.
Sync Out Connector for future enhancement.
Clock Out SMA type connector to provide a high speed clock that is related to the sample rate.
This output is not affected by the All Outputs Off state.
Clock In SMA type connector to provide an external clock signal.
Ref In SMA type input connector to provide a reference timing signal (variable or fixed).
10 MHz Ref Out SMA type output connector to provide a 10 MHz reference timing signal.
This output is not affected by the All Outputs Off state.
Touchscreen interface
The arbitrary waveform generator offers a touchscreen interface that you can use to access all features and controls.
Enable or disable the touchscreen interface via the user Preferences on the Utilities tab.
When the touchscreen is enabled, you can use your finger or a stylus to control all operations of the instrument from the display.
The touchscreen can be used alone or in combination with a mouse and front-panel controls.
Operation basics
24 AWG5200 Series Installation and Safety Instructions
To Next Page
Loading...
Need help?
General
