Getting Started
CFG253 User Manual
3
WARNING. To prevent electrical shock, connect the power cord to a
properly grounded power source. The outside (ground) of this
connector is connected through the equipment to the power source
ground. Do not remove the ground lug from the power cord for any
reason.
3. Connect the input power cord. Use only the power cords specified
for this equipment. Refer to Appendix C: Replaceable Parts on
page 15 for power cord part numbers.
Front Panel
Figure 2 shows the front panel controls, connectors, and indicators
with brief descriptions of the items listed following the figure.
15
51
714 12 11
4
3
10 8913
6
2
Figure 2: Front Panel Controls, Connectors, and Indicators
1. POWER On Light. When lighted, indicates a power on condition.
2. AMPLITUDE Control. This variable control, depending on the
position of the VOLTS OUT button, determines the level of the
signal at the MAIN output connector.
To Next Page
Loading...
Need help?
General
