EasyManuals Logo
Home>Tektronix>Portable Generator>CFG253

Tektronix CFG253 User Manual

Tektronix CFG253
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Reference
8
CFG253 User Manual
External Sweep
To use the external sweep function, follow these steps:
1. Connect the BNC connector to the MAIN OUTPUT as shown
below.
Voltage source
CFG253
Test oscilloscope
To VCF INPUT
(on rear panel)
MAIN OUTPUT
2. Turn the FREQUENCY dial to the .3 position.
CAUTION. To avoid damage to theCFG253 Function Generator,
ensure that the maximum voltage into the rear panel VCF input is no
more than ±10 V pk.
3. Connect the external voltage signal to the VCF INPUT on the
rear panel of the instrument.
4. Push the SWEEP button out to deactivate the internal sweep
function.
When using an external sweep signal, the sweep width and sweep
rate knobs have no effect on the signal sweep. Instead, these
parameters are controlled entirely by the external signal provided
through the rear panel.

Other manuals for Tektronix CFG253

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix CFG253 and is the answer not in the manual?

Tektronix CFG253 Specifications

General IconGeneral
BrandTektronix
ModelCFG253
CategoryPortable Generator
LanguageEnglish

Related product manuals