Getting Started with the MSO/DPO2000 , M SO/DPO30 00, and MSO/DPO4000 Series Oscilloscopes
Demo II: Using Vertical Controls
1. Turn the front-panel channel 1 Vertical
Scale knob in both directions and observe
how the display changes. Also, notice the
channel 1 readout on the lower left of the
display shows the current volts/div setting.
Set the Vertical Scale to 1 V/div.
2. Turn the front-panel channel 1 Vertical
Position knob in both directions and
observe how the display changes. Position
the w avef orm in the center of the display.
6 Demo 2 Boa rd Instruction M a nual
To Next Page
Loading...
Need help?
General
