Commands Listed in Alphabetical Order
Examples
MEASUREMENT:I
MMED:SOURCE1 MATH1
specifies Math1 as t he immediate measurement source.
MEASUREMENT:IMMED:SOURCE1 ? might return
:MEASUREMENT:IMMED:SOURCE 1 CH3 indicating th
at channel 3 is the
immediate measurement source.
MEASUrement:IMMed:SOUrce2
Sets or returns the source to measure "to" for phase or delay immediate
measurements.
NOTE. Sourc e2 measurements only apply to phase and delay measurement types,
which require both a target (Source1) and r
eference (Source2) source.
Group
Measurement
Syntax
MEASUrement:IMMed:SOUrce2 {CH<x>|MATH< y>|REF<x>}
MEASUrement:IMMed:SOUrce2 ?
Related Commands
MEASUrement:IMMed:SOUrce1
Arguments
CH<x> is an input channel waveform, where x is the channel number.
MATH<y> is a math waveform. The y variable can be expressed as an integer of 1.
REF<X> is a reference waveform, where x is the reference channel number.
Examples
MEASUREMENT:IMMED:SOURCE2 REF2 sets the waveform in reference memory
location 2 as the delay "to" source when making delay m easurements.
MEASUREMENT:IMMED:SOURCE2 ? might return
:MEASUREMENT:IMMED:SOURCE 2 MATH1 indicating that Math1 is the
immediate measurement source.
MEASUrement:IMMed:SOUrce<x>
For SOURce1: Sets or returns the source for all single channel measurements. For
delay or phase measurements, sets or returns the waveform to measure "from".
2-190 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
