Command Groups
Cursor Comman
dGroup
Use the commands in the Cursor Command Group to control the cursor display
and readout. You can use these commands to control the setups for cursor 1 and
cursor 2, suc
h as cursor position.
You can also use the commands to select one of the following cursor functions:
Off. Turns off the display of all cursors.
Waveform Cursors. Consists of two cursors. Waveform cursors enable you to
conveniently measure waveform amplitude and time.
Screen Cursors. Consists of two pairs of independent horizontal and vertical
cursors. You can use these cursors to indicate an arbitrary position within
the waveform display area.
Table 2-17: Cursor Commands
Command
Description
CURSor?
Returns c ursor settings
CURSor:FUNCtion Sets or returns the cursor type
CURSor:HBArs?
Returns hbar cursor settings
CURSor:HBArs:DELTa? Returns hbars cursors vertical difference
CURSor:HBArs:POSITION<x> Sets or returns the hbar cursor<x> vertical
position
CURSor:HBArs:UNIts
Returns hbar cursor units
CURSor:HBArs:USE Sets the horizontal bar cursor measurement
scale
CURSor:MODe Sets or returns whether cursors move in
unison or separately
CURSor:VBArs? Sets or returns the position of vertical bar
cursors
CURSor:VBArs:ALTERNATE<x>? Returns the alternate r eadout for the
waveform (Vbar) cursors
CURSor:VBArs:DELTa? Returns the difference between vbar cursors
CURSor:VBArs:HPOS<x>? Returns the horizontal value of the specified
vertical bar ticks
CURSor:VBArs:POSITION<x> Sets or returns the vbar cursor<x> horizontal
position
CURSor:VBArs:UNIts Sets or returns the units for vbar cursors
CURSor:VBArs:USE Sets the vertical bar cursor measurement
scale
CURSor:VBArs:VDELTa? Returns the vertical difference between the
two vertical bar cursor ticks
CURSor:XY:POLar:RADIUS:DELta? Returns the difference between the cursors
X radius and the c ursor Y radius
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-17
To Next Page
Loading...
Need help?
General
