Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
WFMOutpre:XZEro?
Related Commands
DATa:SOUrce, WFMOutpre:XUNit?
Examples
WFMOUTPRE:XZERO? might return :WFMOUTPRE:XZERO 5.6300E-9 indicating
that the trigger occurred 5.63 ns before the first sample in the waveform record.
WFMOutpre:YMUlt? (Query Only)
Returns the vertical scale factor per digitizing level in units specified by
WFMOutpre:YUNit for the waveform specified by the DATa:SOUrce command.
The query command will time out and an error is generated if the waveform
specified by DATa:SOUrce is not turned on.
See the description of WFMInpre:YMUlt to see how this scale factor is used to
convert waveform sample values to volts.
Group
Waveform Transfer
Syntax
WFMOutpre:YMUlt?
Related Commands
DATa:SOUrce, WFMInpre:YMUlt
Examples
WFMOUTPRE:YMULT? might return :WFMOUTPRE:YMULT 4.0000E-3 indicating
that the vertical scale for the corresponding waveform is 100 mV/div (for 8-bit
waveform data).
WFMOutpre:YOFf? (Query Only)
Returns the vertical position in digitizing levels for the waveform specified by the
DATa:SOUrce command. The query command will time out and an error will be
generated if the waveform specified by DATa:SOUrce is not turned on.
See the description of WFMInpre:YOFf to see how this position is used to convert
waveform sample values to volts.
Group
Waveform Transfer
2-372 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
