Tektronix KEITHLEY 2200 Series User Manual

Commands Listed in Alphabetical Order
*SRE
(Service Request Enable) sets and queries the bits in the Service Request Enable
Register (SRER). Refer to the Status and Events chapter for more information.
Group
Status
Syntax
*SRE <N R1>
*SRE?
Related Commands
*CLS, *ESR?, *PSC
Arguments
<NR1> is an integer value in the range from 0 to 255. The binary bits of the SRER
are set according to this value. Using an out-of-range value causes an execution
error. The power-on default for SRER is 0 if *PSC is 1. If *PSC is 0, the SRER
maintains its value through a power cycle.
Examples
*SRE 48 sets the bits in the SRER to 00110000 binary.
*SRE? might return a v alue of 32, showing that the bits in the SRER have the
binary value 00100000.
STATus:OPERation:ENABle
This command sets and queries the contents of the operation enable register
(OENR). The OENR is an eight-bit mask register that determines which bits in
the Operation Event Register (OEVR) will affect the state of the OPER bit in the
Status Byte Register (SBR). Details about the status registers are available in this
manual. (See page 3-1, Status and Events.)
Group
Status
Syntax
STATus:OPERation:ENABle <N R1>
STATus:OPERation:ENABle?
Related Commands
*PSC, STATus:OPERation:INSTrument[:EVENt]?
Arguments
<mask>::=<NR1>
where
<NR1> is a decimal integer ranging from 0 through 255. The binary bits of the
OENR are set according to this value.
Series 2200 Programmable Multichannel DC Power Supplies Programmer Manual 2-37

Tektronix KEITHLEY 2200 Series Specifications

General

Brand	Tektronix
Model	KEITHLEY 2200 Series
Category	Power Supply
Language	English