Unlocking calibration by remote
To unlock calibration via remote, send the following command:
:CAL:PROT:CODE '<password>'
For example, the following command uses the default password:
:CAL:PROT:CODE 'KI002410'
Changing the password
The default password may be changed from the front panel or via remote as discussed below.
Changing the password from the front panel
Follow the steps below to change the password from the front panel:
1. Press the MENU key, then choose CAL and press ENTER. The instrument will display
the followin
g:
CALIBRATION
UNLOCK EXECUTE VIEW-DATES
SAVE LOCK CHANGE-PASSWORD
2. Select UNLOCK, and then enter the password. (Default: 002410.)
3. Select CHANGE-PASSWORD, and then press ENTER. Th
e instrument will display the
following:
New Pwd: 002410
Use , , ▲, ▼, ENTER, or EXIT.
4. Using the range keys, and the left and right arrow keys, enter the new password on the
display.
5. Once the desired password is displayed, press the ENTER key to store the new
password.
Changing the password by remote
To change the calibration password by remote, first send the present password, and then send
the new password. For example, the following command sequence changes the password from
the 'KI002410' remote default to 'KI_CAL':
:CAL:PROT:CODE 'KI002410'
:CAL:PROT:CODE 'KI_CAL'
You can use any combination of letters and numbers up to a maximum of eight characters.
NOTE If
you change the first two characters of the password to something other than "KI,"
you will no
t be able to unlock calibration from the front panel.
Calibration 2-7
2410-902-01.book Page 7 Monday, November 7, 2005 2:49 PM
To Next Page
Need help?
General
