Tektronix MDO4000B Series Declassification And Security Instructions

Clear a nd Sanitize Procedures
Sanitizing an
Application Module
To sanitize an a pplication m odule, follow this procedure to return the module to
the default s tate.
NOTE. This p
rocedure is for an application module that has its license transferred
to an oscilloscope. If the module license is not installed in an oscilloscope, the
module is already in the default state.
1. With the application m odule installed in an oscilloscope that contains the
module’s license, push the front-panel oscilloscope Utility button.
2. Use the Multipurpose a knob to select Config.
3. Select A
pplication Module Licenses.
4. Under the Transfer Licenses menu, s elect to transfe r the license to the desired
applic
ation module. For e xample, to sanitize the D PO4AERO module, select:
Transfer DPO4AERO License to Module.
NOTE. If the module cannot be selected in the menu, this indicates that the module
license is not contained in that oscilloscope. Install the module in an oscilloscope
that does contain the module license and then perform step 4.
5. The module is returned to the default state.
Declassification and Security Instructions 7

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English