Getting Started with the MSO/DPO2000 , M SO/DPO30 00, and MSO/DPO4000 Series Oscilloscopes
Demo IV: Using Run/Stop Controls
1. Push the Run/Stop button. This stops
acquisitions with the last acquired
waveform on the display.
2. Push Single to have the oscilloscope
acquire a single waveform and then stop.
3. Push the Run/Sto p button again to restart
acquisitions.
Demo V: Using Trigger Controls
1. Turn the Trigger Level knob in both
directions and observe the display. Turn it
far enough to move the trigger leve l off the
waveform.
Demo 2 Board Instruction Manua l 9
To Next Page
Loading...
Need help?
General
