Installing your instrument
Check shipped accessories
Make sure that you received everything you ordered. If anything is missing, contact Tektronix Customer Support. In North
America, call 1-800-833-9200. Worldwide, visit www.tek.com to find contacts in your area.
Check the packing list that came with your instrument to verify that you have received all ordered items. Check that you received
all standard accessories.
Item Quantity Tektronix part number
5 Series Mixed Signal Oscilloscope (MSO54, MSO56, MSO58) Installation
and Safety Manual
1 071-3514-xx
TPP0500B Passive Voltage Probe (500 MHz bandwidth). Shipped with
350 MHz and 500 MHz models.
One per channel TPP0500B
TPP1000 Passive Voltage Probe (1 GHz bandwidth). Shipped with 1 GHz
and 2 GHz models.
One per channel TPP1000
Front cover 1 200-5406-xx
Accessory pouch (attached to front cover) 1 016-2106-xx
Mouse (wired with USB connector) 1 119-7054-xx
Power cord 1 Depends on region
Calibration certificate 1 N/A
If you purchased factory installed options such as Advanced Serial Triggering, tap Help > About to confirm that the option(s) are
listed in the Installed Options table.
Safely rotate the handle
Use the correct process to eliminate the chance of pinching your thumb or rear-panel-connected cables while rotating the handle.
CAUTION. Hold the top of the handle to rotate the handle on the instrument. Do not hold the handle from the sides and rotate, as
this can pinch the base of your thumb between the handle and the case.
If you have routed any cables between the handle and the case, be careful when rotating the handle so that you do not pinch the
cables.
MSO54, MSO56, MSO58 Installation and Safety Manual 1
To Next Page
Loading...
Need help?
General
