Unpacking and repacking instructions
This section contains the information needed to unpack the oscilloscope and
repack it for shipment or storage.
Unpacking
The oscilloscope and its standard accessories are carefully packed at the factory
in a shipping carton. If, upon receipt, damage to the shipping carton is evident,
tell the shipper. Tektronix, Inc. is not responsible for damage caused during
shipping.
If you have not already done so, carefully remove the oscilloscope and its
accessories from the shipping carton and inspect them for damage. Save the
shipping carton for repacking or storage.
Repacking
Use a corrugated cardboard shipping carton having a test strength of at least
275 pounds (125 kg) and with an inside dimension at least six inches (15.25 cm)
greater than the instrument dimensions.
If the instrument is being shipped to a Tektronix Service Center, enclose the
following information:
■
The owner’s address
■
Name and phone number of a contact person
■
Type and serial number of the instrument
■
Reason for returning
■
A complete description of the service required
Seal the shipping carton with an industrial stapler or strapping tape.
Mark the address of the Tektronix Service Center and also your own return
address on the shipping carton in two prominent locations. See
www.tektronix.com/service to find a service center near you.
Storage
The oscilloscope should be stored in a clean, dry environment. The following
environmental characteristics apply for both shipping and storage:
■
Temperature range: -4 °F to +140 °F (-20 °C to +60 °C)
■
Altitude: To 39,370 feet (12,000 m )
See the Tektronix TBS2000B Series Digital Storage Oscilloscopes Specifications
and Performance Verification Technical Reference (Tektronix part number
077-1148-xx) for a complete listing of the environmental specifications.
Maintenance
TBS2000B Series Service Manual 19
To Next Page
Loading...
Need help?
General
