To Next Page

To Previous Page

Command Groups

TDS200/1000/2000 Series Oscilloscope Programmer Manual

2−27

Table 2−20: Vertical commands (Cont.)

Header Description

CH<x>:VOLts Same as CH<x>:SCAle

SELect:<wfm> Set/query waveform display state

All oscilloscope, firmware version, and module combinations

except TDS210 and TDS220 with firmware below V 2.00 and a

TDS2CMA communications module.

Waveform Commands

Waveform commands let you transfer waveform data points to and

from the oscilloscope. Waveform data points are a collection of

values that define a waveform. One data value usually represents one

data point in the waveform record. When working with peak-detect

waveforms, each data value is either the min or max of a min/max

pair. Before you can transfer waveform data, you must specify the

data format and waveform locations.

Table 2-21 lists and describes Waveform commands. Refer to the

text following this table for more information about waveform

commands.

Table 2−21: Waveform commands

Header Description

CURVe Transfer waveform data to or from the

oscilloscope

DATa Set/query the waveform data format and

location

DATa:DESTination Set/query the destination for waveforms

sent to the oscilloscope

DATa:ENCdg Set/query the waveform data encoding

method

DATa:SOUrce Set/query the source of CURVe? data

Tektronix TDS2012 Programmer's Manual

Other manuals for Tektronix TDS2012