Maintenance
TDS1000 and TDS2000 Series Digital Storage Oscilloscopes Service Manual
6-- 5
Removal and Installation Procedures
This section describes how to remove and install the major mechanical and
electrical modules. It provides the following information:
H Required Tools on page 6--6 describes the tools needed to perform the
procedures.
H List of Modules on page 6--5 describes where to locate a list of replaceable
modules.
H Summary of Procedures on page 6--6 lists the procedures for removal and
installation of modules.
H Rear Feet, on page 6--7, begins a series of procedures that describe the
removal and installation of modules.
Read this section to prepare for module removal and installation.
WARNING. Only qualified personnel should perform service procedures. Before
doing this or any other procedure in this manual, read the General Safety
Summary and Service Safety Summary found at the beginning of this manual.
Always disconnect the power cord before disassembling any portion of the
oscilloscope.
To prevent damage to electrical components, read Preventing ESD on page 6--1.
H See Figure 8--1 on page 8--7 for an overview of how the entire oscilloscope is
assembled.
H Read the Summary of Procedures on page 6--6 to understand which
procedure to use to access a given module. Then read Required Tools on
page 6--6 for a list of tools needed to remove and install modules in the
oscilloscope.
H If you are disassembling the oscilloscope for cleaning, refer to Inspection
and Cleaning on page 6--2 for cleaning instructions.
The Replaceable Parts List provides a list of all replaceable modules. Any
electrical or mechanical module, assembly, or part listed in the parts list is
referred to as a module.
Preparation
List of Modules
To Next Page
Loading...
Need help?
General
