Maintenance
TDS3000C Series S ervice Manual
4-9
Metal
pin
Handle
Hub
Assembly
Figure 4- 1: Pulling the hub pin
5. Place the oscilloscope on its feet on soft surface (such as an anti-static mat),
with the display-side hub facing you.
6. Rotate the handle two detent positions toward the rear of the oscilloscope.
The hub should rotate with the handle. If the hub does not rotate with the
handle, return the handle to the upright position, pull the pin out a little
farther, and then rotate the handle toward the rear of the oscilloscope.
7. Pull outward on the handle at the hub to release the display-side hub
assembly. You may need to rotate the handle up and down slightly to help
release the hub assembly. See Figure 4--2.
To Next Page
Loading...
Need help?
General
