Basic Installation
Table 1: Access
ory connection information
Item Description
Monitor
Ifyouuseanon
plug & play monitor, you
may need to change the Windows display
settings to achieve the proper resolution.
Printer
Connect the printer to the LPT (parallel) port.
Rackmount The logic analyzer can be installed in
rackmount kits. Refer to the respective
rackmount ki
t instructions for installation
information.
Connecting
Probes
After you have connected all the accessories, you can conne ct the probes to the
instrument. Refer to the appropriate section for your instrument.
For additional information on the individual probes, refer to the instructions that
accompanied your probes.
CAUTION.
When attaching the probe to the logic analyzer, you must use care to
evenly tighten probe screws until they are snug. First slightly tighten screws, then
snug each screw to 4 in-lbs (max). Undertightening the probe screws can result in
intermittent performance. Over tightening can re sult in stripped screws.
Connect the logic analyzer probes and the optional retaining brackets as shown.
(See Figure 3.)
4 TLA5000 Series Logic Analyzer Installation Manual
To Next Page
Loading...
Need help?
General
