Tektronix TLA5000 Series User Manual

Removal and Installation Procedures
6-24
TLA5000 Series Service Manual
Front Panel Keypad
1. Remove the trim and covers by following the procedure on page 6--6.
2. Remove the front panel knobs.
3. Remove the front panel assembly.
4. Remove the front panel board.
5. Remove the Front Panel keypad:
6. Pull on each of the keypad support guides to separate the keypad from the
Front panel board. Use a pair of tweezers or equivalent tool to pull the
twelve keypad support guides.
7. Remove the keypad from the front panel board.
T-15 Torx-drive
screws (8)
Pry point
access hole
Keypad support
guide (13)
Front panel board
Keypad
Alignment stud Pry point
access hole
Figure 6- 12: Front panel board & keyboard removal

Tektronix TLA5000 Series Specifications

General

Brand	Tektronix
Model	TLA5000 Series
Category	Measuring Instruments
Language	English