Tenda HG9 User Manual

Tips:
When the ONT is set to Bridge mode, please configure internet settings based on ISP requirement.
Tips:
If you cannot access the internet after the configuration, refer to Q2 in FAQ.
If you want to change the Wi-Fi name and Wi-Fi password, refer to Q6 in FAQ.
Computer
Ethernet cable
1 2
Access internet over PPPoE
Bridge mode
➊ Connect a LAN port of the ONT to the WAN port of a router using an Ethernet cable.
➋ Connect the computer to a LAN port of the router using an Ethernet cable.
➌ Set up a PPPoE connection on the router as required.
After the settings, you can access the internet through the router.
Done.
To access the internet:
Connect your wired device, such as a computer, to a LAN port of the ONT.
Connect your wireless device, such as a smartphone, to the Wi-Fi networks of the ONT,
using the SSID (Wi-Fi name) and Key (Wi-Fi password) on the bottom label.
Power source
Power source
Ethernet cable
WPSReset
WAN
1
2
IPTV/3
POWER
WAN LAN
LAN
Internet
ONT
7
Router

Tenda HG9 Specifications

General

ITU standards	G.984.1, G.984.2, G.984.3, G.984.4
Networking standards	IEEE 802.1Q, IEEE 802.3u, IEEE 802.3z
Transmission distance (max)	20 km
Wi-Fi	Yes
Antennas quantity	2
Antenna gain level (max)	6 dBi
Fiber ports quantity	1
Fiber optic connector	SC
Ethernet LAN (RJ-45) ports	4
Product type	Optical network terminal (ONT)
Product color	White
Power consumption (typical)	18 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	124.9 mm
Width	190 mm
Height	26.5 mm