Texecom Veritas Excel User Manual

Master User Programming Veritas Excel User Guide
18 INS166
There are eight possible User Access Levels:
User
%
A User may set, unset, silence an alarm and reset the system. In addition a User
can test the system outputs, perform a walk test and view the event log. A User
cannot change Access codes (other than their own) or Access Levels.
Engineer
&
Engineers cannot change Access Levels or Access codes (other than their own).
However they can access all system programming options.
Personal Attack
!
Entering a PA code will cause an immediate alarm, sounding both the internal
and external sounders.
Duress
'
A Duress code behaves exactly as a User code (Level 1) but will in addition
activate the Duress channel on the communicator interface to secretly summon
assistance.
Master User
1
A Master User may set, unset, silence an alarm and reset the system. In addition
a Master can test the system outputs, perform a walk test and view the event log.
A Master User can also assign new user Access code and Access Levels.
Cleaner
.
If the system is full set or part set then a Cleaner code will automatically omit the
Cleaner Suite zones without affecting the other zones. In addition pressing a key
will NOT cause the system to start entry mode. On leaving, the cleaner should
enter their Access code
####
and press either
$
or
(
. The
)
key is disabled and the previous set will be restored irrespective of which
key was pressed. A cleaner cannot access Chime. Nor can they cancel an alarm
or reset the system.
! "
When a cleaner is Setting the system the Cleaner Suite zones will flash
indicating that they are currently omitted but are about to be re-included.
Any other omitted zones (e.g. if the system was previously part set rather
than full set) will also flash but will NOT be included.
If the system is unset then a cleaner can full set, part set and omit zones.

Texecom Veritas Excel Specifications

General

Brand	Texecom
Model	Veritas Excel
Category	Keypad
Language	English