Texecom Veritas RKP User Manual

2 INS037-5
1 INSTALLATION
The Veritas Remote Keypad (RKP) is suitable for use with
the Veritas range of Control Panels.
1. Up to 6 keypads may be used in total.
2. The Unset LED on the keypad will flash during entry
or to indicate a power fault.
1.1 Mounting
Open the keypad by carefully inserting a small flat-blade
screwdriver into either half of the double slot at the base of
the unit. Gently twist the screwdriver to ease the retaining
clip upwards. Do NOT use excessive force. The front and
flap can now be removed.
The PCB assembly is hinged for easy access. Alternatively
the PCB assembly can be unclipped and completely
removed if required.
Mount the keypad using at least two appropriate
countersunk screws (no larger than No. 6). A keyhole slot
has been provided to assist mounting and aid levelling.
1.2 Wiring
It is strongly recommended that the system is completely
powered down (mains and battery) before wiring a keypad.

Texecom Veritas RKP Specifications

General

Brand	Texecom
Model	Veritas RKP
Category	Keypad
Language	English