04/03/2015 Orion - Gulliver User Manual
10
3.4 Display
The display is found inside of the cabin on the central button panel (except in the Elegance version)
and comes into function each time that the platform elevator is used. The display shuts off after 30
seconds idle time of the internal or external commands.
In some cases the images visualised on the display may be accompanied by an acoustic signal.
Below the legend of the illustrations:
Floor 0: the platform has arrived at floor 0 (it is therefore possible to release the button).
Floor 1: the platform has arrived at floor 1 (it is therefore possible to release the button).
Floor 2: the platform has arrived at floor 2 (it is therefore possible to release the button).
Floor 3: the platform has arrived at floor 3 (it is therefore possible to release the button).
Floor 4: the platform has arrived at floor 4 (it is therefore possible to release the button).
Platform in use: this is activated upon pressing of one of the floor buttons on the central button panel (inside
of the cabin).
Platform in movement: the platform is in movement toward one of the lower floors.
Platform in movement: the platform is in movement toward one of the upper floors.
Constant pressure: the command has been released before arrival at the floor selected (hold the button
down to arrive at the floor desired).
General alarm / No main power: the system is being battery-operated or the general alarm with siren is
active.
Overload: Signals that the maximum load permitted has been exceeded (Optional); the plant system does
not work. It will be necessary to check the load and in case of necessity contact Service Assistance)
Safety stop: Intervention of one of the safety devices: (verify the status of the emergency button and in case
it has been released, contact the designated service assistance).
Door open: One of the doors in the plant system has not been closed correctly (the plant system does not
work. Close the door to recover the normal operation of the platform).
Automatic descent to the ground floor (optional).
ThyssenKrupp Logo: visible in stand-by situations or in the case of the automatic levelling movement at a
floor. It shuts itself off after a maximum time of 30 seconds.
To Next Page
Loading...
Need help?
General
