1212
4
Dispensing Hot Water
3
Press the
Unlock
key once.
The Dispense lever will be locked, and hot water
cannot be dispensed even if the key is pressed.
Light
turns o
Beeping
sound
■Refill water when level becomes low.
Be sure to refill water before it reaches [Refill water mark],
and close the lid securely. (Caution for hot steam when
refilling water. See p. 10)
Do not leave the unit without any water
inside, this is to avoid malfunction due to
boiling without water.
1
Press the
Unlock
key once.
Light
illuminates
Beeping
sound
2
Press the
Dispense lever.
Place a container under the spout, and press the
Dispense lever.
Hot water continues to dispense while pressing the lever.
※
After checking that hot water has stopped dispensing, remove the
container from the spout
※
If the unit is unplugged, hot water cannot be dispensed.
※
When water is boiled, air pressure increases in the container so
that the water dispenser may not produce a smooth water flow
immediately after its boiled. Release the air pressure by opening
the lid and then dispense the water. Caution for hot steam.
※
Mineral deposits can build on the wall of the inner container, mesh
filter or pump unit, causing water to not dispense.
※
If the Dispense lever is not pressed for approx. 10 seconds after
dispensing hot water, the unlock lamp will be turned off and the
unit will lock automatically.
•
Do not dispense when water level is
at "Refill water mark". Hot water may
splash when you dispense.
•
Pay close attention when dispensing
hot water so as to not spin the entire
unit around.
To Next Page
Loading...
Need help?
General
