2
Remove the lid
While pressing down on the attach / remove lever for the
lid, open and remove the lid by pulling the lid toward the
spout.
3
Discard remaining hot water
(Refer to
p. 8
)
•
Move the unit to the kitchen sink and
then discard water slowly. Caution
for hot water may splash during this
operation.
•
Watch out for hot water dripping from
the spout immediately after discarding
the hot water.
•
Be sure to clean the inner container
and mesh filter. (Refer to p. 16)
4
Attach the lid
While pressing down on the attach/remove lever for the
lid, insert the hook-on part of the lid.
•
Do not leave hot water remaining
inside the container, this is to avoid
discoloration of the inside container or
foul odors from forming.
•
Do not turn the spout downward with
the lid on, or discard hot water from the
hinge area, this is to avoid scalds from
splashing hot water or malfunction.
•
Pay extra attention when discarding the
remaining hot water, as the mesh filter
may fall if it is not properly attached.
To Next Page
Loading...
Need help?
General
