ENGINE OPERATION36
7
9. After engine starts, do not reinstall
flywheel cover and top cowl.
ENOM00518-0
If the choke solenoid fails to
operate (EP type only)
1. Pull the choke knob fully.
2. Raise the Free accel lever a little.
3. Turn the main switch key to start
position.
4. Stop pushing the key when the engine
has started.
5. Return the choke knob.
1. Choke knob
ENOM00043-A
ENOW00932-0
Be sure to check that cooling water is com-
ing out of the cooling water check port
during warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
-1
(rpm) :
above 5°C (41°F)
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
1. Cooling water check port
2. Idle port
ENOM00044-A
Engine speeds
Idling speed after warming up.
ENOF01740-0
1
3. Warming up the engine
CAUTION
Trolling speed
(In Forward)
Idling speed
(in Neutral)
800 min
-1
(rpm) 950 min
-1
(rpm)
To Next Page
Loading...
Need help?
General
