REMOVING AND CARRYING THE OUTBOARD MOTOR48
8
ENON00021-C
Note
If the outboard motor must be laid down,
be sure drain the fuel from the fuel line
and carburetor in advance, then the port
side face down on the cushion as shown in
the drawing.
1. Handle
ENOM00072-A
ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak, poten-
tially catching fire.
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor still attached,
disconnect the fuel line from the out-
board motor beforehand and keep the
outboard motor in the normal running
position or on a transom saver bar.
Tiller handle type
To prevent the outboard motor from
moving when it is attached on a boat
during transport on a trailer, properly
tighten the steering friction bolt
(page 50).
3. Trailering
CAUTION
WARNING
WARNING
CAUTION
To Next Page
Loading...
Need help?
General
