PRE-OPERATING PREPARATIONS
1-10min 10min-2hrs 2-3hrs 3-10hrs After 10hrs
Throttle Position Idle
Less than 1/2
throttle
Less than 3/4
throttle
3/4 throttle
Full throttle
available
Speed
Approx.
3,000 rpm max
Full throttle run
allowed for 1 min
every 10 min
Approx.
4,000 rpm.
Full throttle run
allowed for 2 min
every 10 min
Your new outboard motor and lower
unit require break-in for the moving
c o m p o n e n t s a c c o r d i n g t o t h e
conditions described in the following
time table.
Fuel mix ratio for break-in
Gasoline 25: Genuine Engine Oil 1
●
25:1 when using genuine engine oil
or the recommended one (TCW3).
4
31
3. Break-in
Note
Proper break-in allows outboard motor
to deliver it full performance for longer
service life.
Do not operate the outboard motor
in closed area or area with no forced
ventilation.
Exhaust gas emitted by this outboard
motor contains carbon monoxide
that will cause death if inhaled
continuously. Inhaling the gas initially
causes symptoms such as feeling of
sickness, drowsiness and headache.
During operation of the outboard
motor :
• Keep peripheral area well
ventilated.
• Always attempt to stay on the
windward side of emission.
Operating the outboard motor without
break-in can shorten service life of the
product.
If any abnormality is experienced
during the break-in:
• Discontinue the operation
immediately.
• Have the dealer check the product
and take proper action(s) if
necessary.
To Next Page
Loading...
Need help?
General
