19
Note: The full strength of the strips will be reached after approximately 72 hours depending
on the temperature.
7. Insert the LINK 510 into the holder. Press gently until it clicks into place.
Attaching the holder using self-tapping screws
You can use two self-tapping screws to fix the holder to your vehicle.
Please refer to the list of what's in the box, to check that the self-tapping screws (3.5 x 16 mm,
1/7 x 5/8 inches) are included in your product package.
1. Choose a flat surface for the LINK 510.
Remember, when the LINK 510 is in the holder, it must not be obstructed by metal objects.
2. Insert the two screws into the corresponding holes in the holder.
3. Tighten the screws.
4. Carefully place the LINK 510 in the holder until it clicks into place.
Attaching the holder using cable ties
You can use two cable ties to fix the holder to your vehicle. Using cable ties might have an impact
on the accuracy of the driving event reporting if the device is not fixed properly.
Please refer to the list of what's in the box, to check that the cable ties (205 x 3.5 mm, 8 x 1/7
inches) are included in your product package.
1. Choose a position where the LINK 510 is not obstructed by metal objects when it is in the
holder.
2. Insert the cable ties into the corresponding holes in the holder.
3. Wrap the cable ties around the object where you want to place the holder.
To Next Page
Loading...
Need help?
General
