25
If your LINK 510 does not operate properly or signals a system error you may need to restart or
reset the unit. Only restart or reset the LINK 510 after you have made sure you have carried out all
previously described steps without success.
Restarting your LINK
To restart your LINK 510, press the reset button with a thin pointed object until it clicks and keep it
pressed down for 1 to 2 seconds. The LINK 510 restarts immediately after releasing the button.
If restarting the device does not succeed remove the power cable from the LINK 510. Then plug it
into the power cable connector again.
Resetting your LINK to factory settings
To reset the LINK 510 to factory settings, press the reset button with a thin pointed object until it
clicks and keep it pressed for 8 seconds. The LINK 510 reboots immediately after releasing the
reset button. You can count the seconds with the help of the flashing of the green LED, that
flashes once per second.
Important: All information stored on the LINK 510 is deleted during a factory reset.
If resetting the device does not succeed, do the following:
1. Remove the power cable from the device.
2. Press the reset button with a thin pointed object until it clicks and keep it pressed.
3. Insert the power cable while keeping the reset button pressed for 8 seconds.
You can count the seconds with the help of the flashing of the green LED, that flashes once
per second.
The LINK 510 reboots immediately after releasing the reset button.
To Next Page
Loading...
Need help?
General
