Lubrication
Greasing Bearings And Bushings
(Fig. 26–32)
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal
conditions, lubricate all bearings and bushings after
every 100 hours of operation. More frequent
lubrication is required if used for heavy-duty vehicle
operations.
The grease fitting locations and quantities are: Tie rod
ends (4) (Fig. 26), Front ball joints (4) (Fig. 26), Rear
drive shafts (18) (Fig. 27) Front pivot bushings (2)
(Fig. 28); Mid drive shaft -4 wd only (3) (Fig. 29);
Pedal Pivots (4) (Fig. 30); Steering shaft (1) (Fig. 31)
and Accelerator Arm (1) (Fig. 32).
When greasing drive shaft universal shaft
bearing crosses, pump grease until it comes out of all 4
cups at each cross.
1. Wipe grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
Figure 26
Figure 27
Figure 28
Important
36
Before servicing or making adjustments to the
machine, stop engine, set parking brake and remove
key from ignition switch. Any load material must be
removed from bed or other attachment before
working under raised bed. Always place the safety
support on extended lift cylinder to hold box up.
WARNING
To Next Page
Loading...
Need help?
General
