Setup
1. Assembling the Blower
Install the blo w er tube and then the inlet co v er onto the blo w er
housing .
Important: Y ou must install the blo w er tube bef or e
installing the inlet co v er because the inlet co v er hooks onto
the blo w er tube. T he blo w er will not r un unless the bottom
inlet co v er is lock ed in place.
2. Converting from Blower to
Vacuum
T he impeller r otates f or a few seconds after y ou tur n of f
the blo w er and can cut or injur e finger s.
Do not r emo v e the bottom inlet co v er when the motor is
r unning or when the unit is plug ged into a po w er outlet.
1. R emo v e the inlet co v er and the blo w er tube from the blo w er
housing .
Figure 3
2. Install the v acuum tube onto the blo w er housing .
Important: T he v acuum will not r un unless the
v acuum tube is lock ed in place.
3
To Next Page
Loading...
Need help?
General