Mowing Overview
1. Transport the machine to the area of operation.
2. Start the engine, set the throttle to a reduced speed, push down on the handle to raise
the cutting unit, and engage the traction drive to move the machine onto the collar of the
green.
3. Stop the machine on the collar.
4. Use the cutting-unit-drive lever to engage the cutting unit, increase the throttle speed
until the machine is traveling at the desired ground speed, engage the traction drive to
move the machine onto the green, lower the cutting unit to the ground, and begin
mowing.
Mowing Tips
IMPORTANT
Grass clippings act as a lubricant when mowing. Operating the cutting unit
excessively without grass clippings can damage the cutting unit.
• Mow the greens in a straight back-and-forth direction across the green.
• Avoid circular mowing or turning the machine on the greens areas to prevent scuffing.
G404724
• Turn the machine off the green by raising the
cutting reel (pushing the handle down) and
performing a tear-shaped turn on the traction
drum.
• Mow at a normal walking pace. Fast speeds
saves little time and results in an inferior
mowing job.
Operation: During Operation Page 5–7 3460-887 A
To Next Page
Loading...
Need help?
General
