20
Installing the remote control
batteries
1無
Remove the battery cover from the back of
the remote control.
Squeeze tab
and lift cover.
2無
Install two “AAA” size batteries, making
sure to match the + and – signs on the
batteries to the signs on the battery
compartment.
3無
Reinsert the battery cover in the remote
control until the tab snaps.
Caution: Batteries must not be exposed
to excessive heat such as sunshine, fire or
the like.
Note:
•
Be sure to use AAA size batteries.
•
Dispose of batteries in a designated disposal
area.
•
Batteries should always be disposed of with
the environment in mind. Always dispose of
batteries in accordance with applicable laws
and regulations.
•
If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace batteries with new ones.
•
When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
•
Always remove batteries from the remote
control if they are dead or if the remote
control is not to be used for an extended
period of time. This will prevent battery acid
from leaking into the battery compartment.
Remote control effective range
For optimum performance, aim the remote control
directly at the TV and make sure there is no
obstruction between the remote control and the TV.
16.4 ft (5m)
Point remote control toward
remote sensor on front of TV.
Chapter 3: Using the remote control
To Next Page
Loading...
Need help?
General
