16
Getting started
Programming channels into the TV’s
channel memory
• First, use the Auto tuning function to preset all
the active channels in your area automatically.
Then, arrange the preset channels with the
Manual tuning function so that you can tune
into only desired channels.
• Use the Manual tuning operation if desired
channels cannot be preset with the Auto
tuning or if you would like to preset channels to
specifi c position numbers one by one.
Auto tuning
1 From the SET UP menu, press V or U to
select Auto tuning.
SET UP
Language
Auto tuning
Manual tuning
Manual setting
AV connection
PC Setting
Picture position
Quick Setup
Location
English
Home
2 Press Q to display the Auto tuning menu.
Auto tuning
Previous settings will be Lost!
Press EXIT for no change.
Press OK key to start auto tune.
3 Press Q to start the automatic search.
The search will begin for all available stations.
Auto tuning
Progress
Found
1% 0
4 When the automatic search is completed,
the TV will automatically appear the Manual
tuning menu.
5 Closing the Auto tuning menu, press P.
Note:
When you preset the channel which sound
of broadcast transmission system adopts “M”
system, the sound system may not be tuned
correctly if the radio waves transmit badly. At that
time, preset the channel by Manual tuning.
The countries such as Myanmar, Brazil, Chile,
Colombia apply to this case. See page 38 for
more details.
Manual tuning
1 From the SET UP menu, press V or U to
select Manual tuning.
2 Press Q to display the Manual tuning menu.
Press V or U to select the programme
position you want to arrange.
1
Manual tuning
Pos. Label
2
3
4
5
6
7
8
3 Press Q to display the breakdown menu.
Press Y or Z to select an item, then press V
or U to select the item as shown below.
Manual tuning
Position
1 B/G A0
ACE G
FDB
A. Position selection
B. System (Sound) (- page 38)
C. Colour system (- page 38)
A : Automatic (factory set), P : PAL,
S : SECAM, 4 : NTSC 4.43 (MHz),
3 : NTSC 3.58 (MHz)
If the colour of a certain channel is
abnormal, the automatic colour system
selection (A) may have malfunctioned, or
sound system selection is wrong. In such
a case, select another colour and/or sound
system (- page 38).
D. Position skip selection
Press V or U to turn the position skip
option on “8” or off “(”.
The position will then be skipped when you
select channels with PU or Pu.
The “8” mark will appear beside a
position number when you use the
Number button on the remote control.
324246RV600ETY_En.indd 16324246RV600ETY_En.indd 16 7/28/2009 11:02:46 AM7/28/2009 11:02:46 AM
To Next Page
Loading...
Need help?
General
