24
Using the TV’s features
2 Press Q.
o 1 (o (1), video 1 input),
o 2 (o (2), video 2 input) or o 2S (S-video
input),
o 3 (o (3), component video input),
o 4 (o (4), component video input),
HDMI1, HDMI2, HDMI3, HDMI4 (HDMI
input),
PC (o RGB/PC, PC input)
Notes:
• When the component video input, PC input
mode or HDMI input mode is selected, the
MONITOR OUT output terminals (- page 30)
output audio signal only.
• If a REGZA-LINK device is connected to an
HDMI input, the REGZA-LINK icon will appear.
• When the TV is switched on, it will take a few
minutes for the REGZA-LINK icon to appear in
the list; when an HDMI cable is removed, it will
take a few minutes for the icon to disappear.
• If the HDMI cable from connected device is
changed or HDMI device setting are changed,
Enable REGZA-LINK in the REGZA-LINK
menu may need to be reset to On.
Setting the manual setting menu
1 Press MENU, then press Y or Z to display
the SET UP menu.
SET UP
Language
Auto tuning
Manual tuning
Manual setting
AV connection
PC Setting
Picture position
Quick Setup
Location
English
Home
2 Press V or U to select Manual setting, then
press Q.
3 Press Y or Z to select an item, and then
press V or U to select the item as shown
below.
Manual setting
Colour system : Auto
EXT1
A
A B
A. Colour system
Confi rm that colour system is set to “A”
(Auto). If not, select “A” with V or U.
Activating blue screen
With the blue screen function On, the screen
will automatically turn blue and the sound will be
muted when no signal is being received.
1 From the FUNCTION menu, press V or U to
select Blue screen.
2 Press Y or Z to select On or Off.
Note:
In the PC input mode, PIP mode (- page 25) or
teletext mode (- page 27), this function is not
available.
Activating the 4:3 stretch
When 4:3 stretch is activated, this function will
switch 4:3 format programmes into a full screen
picture.
1 From the FUNCTION menu, press V or U to
select 4:3 stretch.
2 Press Y or Z to select On or Off.
Note:
In HDMI signal format, this function is available.
Adjusting the brightness of side panel
You can adjust the brightness of side panel in
14:9 or 4:3, etc. mode.
1 From the FUNCTION menu, press V or U to
select Side panel.
2 Press Y or Z to adjust the settings as
required.
Side panel
1
Selecting the video input source to
view
1 Press L on the remote control until the video
input mode list appears on the screen, then
press V, U or L to select appropriate input
source (or press o on the TV right side panel
to select required input source directly).
TV
Inputs
1
2
3
4
HDMI1
HDMI2
HDMI3
HDMI4
PC
324246RV600ETY_En.indd 24324246RV600ETY_En.indd 24 7/28/2009 10:08:15 AM7/28/2009 10:08:15 AM
To Next Page
Loading...
Need help?
General
